Verify your settings with the show answer command. Note that will need to be substituted for the SMS domain used by your provider. If you will be using SMS-initiated PPP, the number and domain are required.
The config answer command allows you to specify device-specific information such as initialization string, phone number, and SIM card domain. 0,5 - The modem is registered on a network and it is roamingįor proper operation, AT+CGREG? should respond with 0,1.0,3 - The modem is not connected to the network.0,2 - The modem is not connected to the network.0,1 - The modem is registered on the home network.0,0 - The modem is not registered on any network.The command will return one of the following responses:
#Apa itu apn registration#
The network registration status is also listed in the show tech output. To determine if the modem is properly connecting to the cellular network, use the AT+CGREG? command. After establishing a console session, AT commands like ATZ or AT+CSQ should return 'OK'. Use the terminal command to ensure a good connection with the modem. Mobile Subscriber Identification Number (AT+CIMI): 906743222 Signal Strength (AT#SERVINFO): (-86) dBm. Network Operator Name (AT#SERVINFO): AT&T
#Apa itu apn code#
Packet Service Type (AT#PSNT?): Unsolicited result code disabled. Network Registration Status (AT+CGREG?): Registered, home network.
#Apa itu apn full#
Modem Functionality Mode (AT+CFUN?): Mobile full functions with power saving disabled. Modem Firmware Version (AT+CGMR): 17.00.503 Pull tech completed and saved as (modem)]# show tech (modem)]# pull techĬhecking International Mobile Subscriber Identity Use the pull tech command and subsequently the show tech to view current modem state. To switch carrier networks:įrom Verizon to AT&T: AT#FWSWITCH=0,1 Testing Connectivity
If the response is #FWSWITCH: 1, the modem is configured for Verizon. If the response is #FWSWITCH: 0, the modem is configured for AT&T/other network. Open a terminal session with the modem, and run the following command: AT#FWSWITCH? To check that your modem is configured for the desired network: This section applies to the following parts only: Modems are factory defaulted for AT&T/other, but may be configured by Uplogix prior to shipment. The modem can operate on either Verzion or AT&T/other networks. MCT-MNA1 and MTD-MNA1 modems use a cellular radio with dual firmware, meaning the device can connect to two different carrier networks (not simultaneously). Configure Carrier (LTE CAT 4 Combo / MNA-1 Modems ONLY) Would you like to reinitialize it? (y/n): yĭo you want to commit these changes? (y/n): y This device has already been initialized. Others must be configured with the config init command before the cellular modem can be used. Embedded modems should automatically configure the appropriate carrier settings for most modems. Log into the Local Manager and access the modem resource using the modem command. This article describes the configuration of a Local Manager with a cellular modem.īefore following the steps in this guide, ensure you have already completed Getting Started with Cellular Modems.